Apply Vinyl Lettering Windex

With some elbow grease the adhesive can be removed.

Apply vinyl lettering windex.

Peel the backing paper from the decal. There are many youtube videos and websites that have great tutorials on how to apply vinyl die cut decals. Peel off the wax paper using a friend to help with bigger decals. Squeegee windex from under the decal beginning in the center and working outward.

Vinyl can be applied to any smooth surface. The adhesive on the back of the vinyl lettering should stick well to your surface if it has been properly cleaned and prepped. The ammonia interferes with the adhesive. Surface should be clean and dry before applying vinyl lettering.

Mild detergents or solvents can be used to remove wax grease tar etc. Apply vinyl lettering to your surface lower the mask layer and using your squeegee press firmly at a 45 degree angle starting from the middle and going out. The vinyl will not stick as well to any oil or waxy surface. Final note the application of this vinyl decal requires a degree of dexterity and concentration.

If you have never applied vinyl die cut decals it is recommend to do a little research online. Only remove the wax paper when you are ready to apply the decal to prevent dirt from getting on the adhesive surface. How to apply vinyl lettering racing stripes vinyl stickers vinyl decals pinstripes and more. If you re applying the decal to glass do not use windex or other ammonia based cleaners.

Wipe away the excess windex and let the decals take a set. If air bubbles occur puncture with a pin and smooth down. Remove the wax paper. Spray the adhesive side of the decal with windex after or as you peel away the backing paper.

Glass cleaners such as windex can be used to remove dirt grit and water soluble substances. Apply water to the back side of the. Use the squeegee to squeeze out all the windex and air bubbles from underneath the decal. Get the best results when applying car window decals by following expert tips.

They are all a little different but very helpful. Apply rubbing alcohol to remove any remaining oils or waxes from the vehicle s surface. Such as metal glass plastic wood wall board etc. Use a little rubbing alcohol to clean the area where the decal will be applied.

To apply a vinyl cut decal prepare the metal as above and wash with soap and water including new paint. This is key and it s a good time to walk away from the car.