Find the lowest corner of the old siding or sheathing on the house.
Applying vinyl siding starter strip.
Hold a tape measure against the exterior wall and travel.
Nail the starter strip to the siding aligning the top of the strip with the chalk line.
How to install a vinyl siding starter strip step 1.
13 simple vinyl siding installation tips use the wider starter strip.
Installing inside corner.
Nail vertical vinyl corners to the corners of the house making sure they are plumb.
This is where the new siding will begin.
Position starter strip with the top edge of chalk line and allow room for corner posts.
Pull the zip tool down while simultaneously.
Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house.
Insulation for vinyl siding 1.
Snap each length of siding in place so that its bottom lip hooks under the starter strip.
Cap the corner posts.
Pop a level chalk line for the starter strip an inch or two above the bottom of the siding.
Staret strip secures the first course of siding to the home.
Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests on top of the starter strip.
The bottom of the starter strip the part the bottom panel hooks on to should be at least.
Partly drive a nail 11 2 in.
Slide it into the corner and nail it every 16 in.
Be sure to center the nails in their slots to.
Pull up as.
In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level.
Attach j channel trim strips around windows and doors and along the eaves.
Mice bees and all sorts of other critters love making their home inside vinyl corner posts.
Locate the lowest possible corner that has sheathing.
Vinyl siding starter strips.
Determine the lowest point of the wall that will be sided.
This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows.