How to set turbo cell type before operation the aqua rite must be configured for the chlorinator cell that will be used.
Aqua rite t cell 15 reset.
How to set turbo cell type to switch cell type cycle main switch from auto super chlorinate auto.
If the incorrect cell is chosen the salt level amperage and voltage will not be correct and the system will turn the chlorinator off.
Its showing salt level of 2700.
Ran through the calibration and all seemed right at 3400.
Waiting to see if that helps.
The first thing to do is to remove the cell and check the blades inside for buildup.
I havent removed the cell yet.
T 15 is the factory default.
Slide the main switch to the auto position.
Here is how to recalibrate a hayward aqua rite turbo cell in three simple steps.
Push 8 cell size the aqua rite scg uses one of 4 cell sizes t 15 t 9 t 5 or t 3.
If the check salt light is lit on a hayward aqua rite salt chlorinator it could mean a number of things.
Low flow conditions can result in insufficient water in the cell causing inefficient chlorine production.
T 1 5 is the factory default.
We often get calls from people having a problem where their hayward aqua rite salt chlorinator system is reading a different salt level than manual testing.
While both the t cell 15 and the t cell 15ll can support pools up to 40 000 gallons in size the regular t cell 15 is designed to produce around 580lbs of chlorine throughout its life before it needs to be replaced.
Came back and looked at the aqua rite the next morning and it reads 2200.
How to reset inspect cell light.
Page 4 before operation the aqua rite must be configured for the chlorinator cell that will be used.
I thought of cleaning the cell because it says on the cell theres a sticker inspect and clean every 3 months.
Replacement turbo salt cell for the goldline aqua rite salt chlorinator from hayward hayward replacement part number t cell 15.
Spoke to hayward and i ended up replacing the t cell 15.
The average salt level needs to be reset for start up and when a cell is replaced.
How to set turbo cell type before operation the aqua rite must be configured for the chlorinator cell that will be used.
6 40 t cell 9.
T 15 is the factory default if the incorrect cell is chosen the salt level amperage and voltage will not be correct and the system will turn the chlorinator off.
As a precaution the cell can be installed vertically or in an inverted manner from the manufacturer.
Water tests at 3500 ppm salt.
It is designed to deliver everything the original t cell 15 already does but with an additional 25 lifespan.
The check salt and inspect cell lights are flashing.
Read out on aqua rite was 2200.
Aqua rite salt chlorinator has a built in reminder to inspect and clean the cell every 500 hrs.
This is a 15000 gallon pool.
Factory default is 2800ppm.
Often times pool owners can solve this by recalibrating the salt cell.
The cell install in this system is t 3.
